posted
I noticed the clean install you did for your seat heater switches. I am planning to install a switch in the same location to manually operate an electric antenna.
How did you remove the plate that contains the power top switch? Where did you tap a power source?
Thanks, Wayne
------------------ '01 SS #1618 Pewter Vert, M6 My Conveyance
posted
The plate pulls straight back ... it's on clips. The rest ... I can't help you with ... the complete install was done by an upholstery shop that does lots of these .... though I've never been able to figure out why
[This message has been edited by poSSum (edited 08 December 2000).]
[This message has been edited by poSSum (edited 08 December 2000).]
Posts: 4222 | From: Winnipeg MB CA | Registered: Feb 2000
| IP: Logged
Printer-friendly view of this topic
