1) The yellow plastic lens broke on the front passenger turn signal. I have discovered this is not just the lens but a unit including the reflector. I cannot figure out how to install this unit on my own. Any help?
2) In the same vain, how do you get to the light bulb for these turn signals as the headlights are indented so much that I cannot even see the wire leading to the turn signal bulb.
Any help is appreciated. Andy-Mario
Posted by 2002Z4CSS (Member # 1393) on :
you should be able to access the lamp assy. and the bulb from the bottom. There should be a plastic panel that can be removed for access. Posted by 97LT1SS (Member # 1353) on :
I had to change both front signal bulbs on my 97. It was a bear to put it mildly. There is a door underneath the nose piece held in place with 2 screws. The door opens down enough to look up inside or stick an arm in, Unfortunately not both. The bulb sockets twist out to remove the bulb. The reflector screws may be in there as well I never had to do that change. Hope that was a little help.
![[Smile]](smile.gif)