Can someone post pics of there SS badges on the fender and on the rear panel also if you could measure from a point so I can have a refrence point to check. My car is coming back from the body shop and I want to make sure the badges are in the correct location.
Thanks
Posted by SS_CarGuy (Member # 2065) on :
I will be e-mailing some pictures to you since I don't have a host site to display them here.
In the meantime, here are some measurements I took:
THE SS letters are spaced properly when they measure 4&1/2 inches from the outer tips of the two S's.
To align them on the front fender, the S that is closest to the door is 3&1/4 inches from the edge of the front fender. And the bottom of the letters should be 1&1/4 inches above the upper crease in the fender (where the moulding goes)
On the rear, place the spacing of the SS so that the opening between the two letters is exactly where an imaginary vertical line would be if you drew it from the bottom of the tailight right between the turn signal and the light. Also the right most "S" will be 11 inches from where the rear fender and the rear valance attach. The Bowtie emblem is 1/4 inch to the left of the SS. The SS letters are 1/2inch below the crease for the tailights and 1/4 inch above the crease closest to the bumper.
I'll get those pictures off to you shortly.
[ 04. September 2003, 11:20 AM: Message edited by: SS_CarGuy ]
Posted by 96ss1664 (Member # 1886) on :
Thanks, I will let you know when I receive the pics, and once again thanks Posted by 2002Z4CSS (Member # 1393) on :
Here is the rear tail panel of my SS.
Side view of the SS
Fender SS emblem
A 2000 SS side view
And a 2000 SS rear view
[ 04. September 2003, 11:30 AM: Message edited by: 2002Z4CSS ]
Posted by 96ss1664 (Member # 1886) on :
SS_Carguy I received the e-mail this helps out a lot, also thanks for the additional pics 2002Z4CSS
![[Big Grin]](biggrin.gif)
