I had my QTP headers and catted y installed a few weeks ago. My SES light was on after the install b/c there were no 02 bungs in the rear. I was told that if i put 02 sims in the rear that the SES light would go off. Well today, I had the 02 sims installed and the light is still on. Do I have to disconnect the battery or anything for it to go off? Thanks!
Posted by Mike2001SS (Member # 2088) on :
Either that or get someone to reset it or it will take so many driving cycals to go off
Posted by DaddySS (Member # 848) on :
Turn the ignition to on, remove the PCM fuse, wait 20 seconds, put fuse back in, start car. The idle will relearn for a few seconds but this will reset the PCM and put the light out.
