posted
The new firebird/trans am instrument cluster bezels/lenses (#16230640)everybody is looking for and can't find (because they were discontinued, and they raised the price a TON if you can find them) are now in stock at McGee's Auto Service, LLC $60.00 each, plus shipping.
Just give Steve a call at 503-635-8252 to order. 8am-5pm M-F Hope this helps anybody who is looking for them. Now you have to buy the entire cluster to get the lens, bummer!
[ 08 March 2002: Message edited by: Steve da Wrench ]
Whoever said you couldn't run away from your problems obviously wasn't driving an SS. Posts: 942 | From: Santa Barbara and Ventura, CA | Registered: Feb 2000
| IP: Logged
Mods: 18x9.5 Y2K C5 wheels w/ 265/35/18 Nitto 555 Extreme tires all the way around LS1 Motorsports Direct-Flo Lid w/ K&N (on order) Hotchkis STB (on order)
Posts: 55 | From: Leesburg, VA | Registered: May 2001
| IP: Logged
quote:Originally posted by HTWLSS: Hmmmmm, note to self....pack very light for the Bowling Green trip so we have room for a pallet of T/A Bezels.......
..... and installation tools. McGee's Mobile Bezel installation service ... the whole trip tax deductible
Posts: 4222 | From: Winnipeg MB CA | Registered: Feb 2000
| IP: Logged
posted
I am there! I need some kind of help to try to get Teri to pack light (maybe I will just TELL her we are bringing a bunch of parts, then at the last minute, change my mind!!!) You guys know how those chicks are on trips!!
The install isn't too difficult. If I can figure out how to scan the details on how to do it, I will repost here. As far as mobil installation, that may be a possiblity, but dont count on it yet.
quote:Originally posted by pharcyde: How difficult are these to install? If they are "easy", then I might get one as well.
Rob.
They sound pretty easy to do, although I have yet to replace ours (no time). Remove LH knee bolster and deflector under the bolster. Remove UPPER(not lower) steering column nuts and lower column. Note: if you are going to disconnect anything attatching to the column, I highly recommend you disconnect the battery 1st, to avoid setting off the airbag). Remove bezel, remove cluster bolts then cluster assy. Remove lens assy from cluster assy. (I have heard you need to break off 1 or 2 tabs on the new lens, but you will have to see which ones). Install new lens, reassemble vehicle. Hope that helps. Let me know if you want one!
BTW, the labor time shows .7 hrs (45 minutes) to perform this operation.
posted
[QUOTE]Originally posted by Steve da Wrench: [QB]
Note: if you are going to disconnect anything attatching to the column, I highly recommend you disconnect the battery 1st, to avoid setting off the airbag).
ouch, that would hurt, getting a face full of air bag. that would suck to learn that the hard way
-------------------- 2002 Navy Blue SS #0214 Hard Top
posted
I want one. Do you still have one? If so do I mail the check to the address where I mailed the RC SS? I promise to be a bit more prompt this time! Posts: 818 | Registered: Feb 2000
| IP: Logged
posted
The shop address is at: 5717 SW Jean Road Lake Oswego, OR 97035
Posts: 7198 | From: Near Portland, Oregon, USA | Registered: Feb 2000
| IP: Logged
Specmo Enterprises. 1-800-545-7910 T/A Bezel Part # 16230640. Credit card or COD only. $30.00 each plus shipping. If you use a credit card, you need to be able to receive and send a fax, either at home or Staples, Office Max, etc. They'll fax a form you sign allowing them to do a one-time charge to your credit card.
Posts: 942 | From: Santa Barbara and Ventura, CA | Registered: Feb 2000
| IP: Logged
Printer-friendly view of this topic
